Spare Drive Belt for Lortone 3A Tumbler

Contains 1 quart of ceramic shapes (CSMs), 1/2 gallon of 220-grit Silicon Carbide (SiC), 1 pint of 600-grit SiC, 1 pint of 1000-grit SiC, 1 pint of Cerium Oxide polish, 1 pint of Tin Oxide polish and...

This is 1.0 pounds of white 1/8-inch diameter polypropylene pellets, at 4.93 per pound, in a 1-quart plastic container.

Many customers have asked to purchase individual templates--here they are!  This is the 12 X 10 mm size.

Polypropylene pellets have been used for many years to cushion loads of softer materials like obsidian.  They tend to embed with Silicon Carbide particles, so they may be re-used only with the...

Contains 1 quart of ceramic shapes, 1/2 Gallon of 80-grit Silicon Carbide, 1 quart of 220-grit SiC, 1 pint of 600-grit SiC, 1 pint of 1000-grit SiC, 1 pint of Cerium Oxide polish, and 1 pint of Tin...

Finally a low-cost way to test the two best rock polishes. This a sample pack of 16 tablespoons of Cerium Oxide Rock Polish plus 16 tablespoons of Tin Oxide Rock Polish--enough for about four...

Tin Oxide is the #2 choice for tumbling hard and soft rocks.  The standard polishing sequence is 2 weeks (continuous) in Cerium Oxide, then 2 weeks (continuous) in Tin Oxide. ...

This is one drive belt for a Tagit Model A-10 vibratory tumbler.  We recommend you keep a spare in your refrigerator in a well-marked zip-close plastic bag--this keeps the material...

This is the O-ring which retains the 3-lb lid and keeps it from leaking.  Not a drive belt!

Just one of these large-hole plastic bearings is required in the 3A Tumbler--it goes on the motor-side of the driving shaft--use three small-hole black bearings for the remaining...